![]() After you attach your Block Storage Volume, the Linode Manager will present command-line instructions for mounting it from your Linode, but you can disregard these. Name the interface and enable DHCP, then click OK.Īdd or attach a Block Storage Volume to the Linode. Select the Interfaces section of the Network tab, and click Add Interface. Use the DNS Resolvers information to fill in the Nameserver fields. ![]() Close any popup menu that appears when you first log in.Ĭlick the Network icon and complete the network information using the Default Gateways and DNS Resolvers found in the Networking tab of the Linode Cloud Manager. Log in with the user root and the password set in Step 4 of the previous section. Use a web browser to navigate to the Linode's IP address. Once booted, close Glish and proceed to the next step to use the web interface for configuration. Use Glish to monitor the first boot which takes several minutes. Select the FreeNAS configuration profile, and click Boot: Press 4 to select Shutdown System, and press Enter to end the session. Press Enter to acknowledge the successful installation message. Press Enter to continue.Įnter a root password, tab to the next field to re-enter it, and press Enter to continue. The installation shows a warning that all data on the disk will be deleted. Press the Spacebar to select the FreeNAS disk ( da0 in this screenshot) and press Enter: Go to the Linode Cloud Manager and access the dashboard for your Linode.Ĭlick the Launch Console link to access the Glish console and start the installation. When the command finishes, reboot into the Installer profile: Once in Rescue Mode, run the following command to set the latest FreeNAS release (11.1 at the time of this writing) as a variable:
0 Comments
Leave a Reply. |